Rear seat delete

Rear delete kit required...

Got some 6mm ply wood as it was the lightest I could find and I am partly past caring for weight so much at this moment. So I made a paper template, cut 3 sections of ply wood

I then used some aluminium brackets bent at 135 degrees to sort the front section and then some hinges in the middle, the sections were then trimmed in carpet 

The back was then trimmed in black ultra suede to cover the inside plywood. I then coloured the staples in after the photo

I then installed the cover, was a pain to get it past the roll cage but after a few attempts I found how to install it but it was tight. Even the lid only opens till it hits the roll cage, not bother as I am not sure I will use the storage for much anyway

Now I need to make a boot carpet as the one I have is a little tatty having spent loads of time in the garage and being 13 years old. Then time to finish the pillars and time for a big clean inside, drivers seat and steering wheel - probably loads more too