Having taken two headlining and cut them up to fit the cars larger roof skin I started to place them in the car, at the moment they are just taped into place but as they are made of GRP they will be fibre glassed together when I next have time
The front section went in really well and actually did not need any tape as the fit was quite tight. All the panels fit flush although without them being fixed they do move about a little
The A pillar covers were cut down to the new height, then plastic welded back together which went really well, ready for a sand and then they will be re-trimmed
The rear section was made of quire a few different sections, I can imagine that this will not be much fun bonding it all together but will be worth it.
Once bonded together I will re-trim in a ultra suede to finish.
The front section went in really well and actually did not need any tape as the fit was quite tight. All the panels fit flush although without them being fixed they do move about a little
The A pillar covers were cut down to the new height, then plastic welded back together which went really well, ready for a sand and then they will be re-trimmed
The rear section was made of quire a few different sections, I can imagine that this will not be much fun bonding it all together but will be worth it.
Once bonded together I will re-trim in a ultra suede to finish.
No comments:
Post a Comment