With many of the engine components rusty from the years of being outside and the small issue of the fire I decided that I wanted to paint everything and make it as new. There are several ways to do this and sand blasting may be used on some of the components being powder coated but I wanted to try electrolysis to remove the rust from more delicate parts.
So here we have the first part subjected to soda electrolysis.
soda electrolysis uses water, tub, sacrificial metal, soda (Not baking soda but washing soda), 12v DC battery charger, any automotive unit can be used. With the positive connected to the sacrificial metal the negative on the part I wish to de-rust the rust will be drawn towards the positive.
Quite soon after connecting and switching on I could see the rust floating in the water which I will try an capture on the camera for later photos. Small bubbles are produced during the process, this is hydrogen being produced so performing this in an open space is a must.
Should take about 24 hours and then I will take another look
Friday, 15 April 2011
Saturday, 2 April 2011
roof skin P2
Over the last few weeks the project had a little struggle mostly being with the roof skin, the part I was most concerned about, while cutting with the angle grinder the skin warped due to the heat, this has made me decide that I will tack the roof skin together and smooth it out. Once smooth the plan is to have a full carbon fibre roof skin made which will be as strong but will be lighter weight than the steel part.
Knowing the plan is now not to use a steel roof I am a little relieved but there is still lots of work needed.
The front section of one roof was cut and mated with the two sides, this helped to give me the shape and strength in the front of the roof
With the front section in I then looked at the side, as it stood there was 2 joins in the side, well 4 in total so I decided to remove the middle part and add a full length piece taken from a spare roof, this went in quite easily and helped with the shape.
Next I just tacked in some pieces to bridge the gap, this will be sorted later, as the roof skin will be smoothed, filled and a mould will be taken from it so strength is not important though the form will be
Well I hope to be able to get the other gaps filled quickly so I can start to filler and shape the roof.
Knowing the plan is now not to use a steel roof I am a little relieved but there is still lots of work needed.
The front section of one roof was cut and mated with the two sides, this helped to give me the shape and strength in the front of the roof
With the front section in I then looked at the side, as it stood there was 2 joins in the side, well 4 in total so I decided to remove the middle part and add a full length piece taken from a spare roof, this went in quite easily and helped with the shape.
Next I just tacked in some pieces to bridge the gap, this will be sorted later, as the roof skin will be smoothed, filled and a mould will be taken from it so strength is not important though the form will be
Well I hope to be able to get the other gaps filled quickly so I can start to filler and shape the roof.
LSD
With the evenings starting again to be longer, I was able to spend some time out in the shed working on the gearbox. The plan is a full over haul of all the seals, bearings, and cleaning of the internal ring magnet.
Once the gearbox was open I took the stock differential out, this is always a job I hate doing as holding everything still and achieving the torque level is difficult without an impact gun. In a short period the quaife limited slip differential (LSD) was installed into the final drive, however I could not do the bolts tights as I need to fetch my loctite 270 from the unit.
Once the gearbox was open I took the stock differential out, this is always a job I hate doing as holding everything still and achieving the torque level is difficult without an impact gun. In a short period the quaife limited slip differential (LSD) was installed into the final drive, however I could not do the bolts tights as I need to fetch my loctite 270 from the unit.
Subscribe to:
Posts (Atom)